Australian Pool Fence Standards Nsw

Safety barriers for swimming pools.

Australian pool fence standards nsw.

Checklist item 1 pool fence according to nsw swimming pool regulation your swimming pool should be surrounded by a sturdy and fully compliant pool barrier. Nsw requirements for pool fences barriers. Not have gaps of more than 10cm between any vertical bars in the fence. As a swimming pool owner you should understand that your pool fence should be at least 1200mm from finished ground level.

This is the australian standard for pools that are constructed. This reduces the effective height of the fence to less than 1800mm. Must not have a gap under it bigger than 10cm again from the finished ground level. And it starts with the ultimate guide to nsw pool fences barriers.

This standard was prepared by the standards australia committee on safety of private swimming pools to supersede as 1926 1986 fences and gates for private swimming pools. This was intended for pool fences and gates for private swimming pools. Trim trees or shrubs near the pool fence and other objects such as bbq pot plants toys ladders and chairs should not encroach within the ncz area. This is to stop small children climbing over it.

This is the standard used for pools that are constructed until 30 august 2008. Pool fence non climable zone ncz australian standard as 1926 1 2012 stipulates that a fence must have a non climbable zone ncz of 900mm on the outside of the pool fence all the way around. In nsw a pool fence must. Be at least 1 2m high as measured from the finished ground level not leave a gap at the bottom bigger than 10cm from the finished ground level.

Australian standard as 1926 1 2012 stipulates that a fence must have a non climbable zone ncz of 900mm on the outside of the pool fence all the way around. Australian standard swimming pool safety part 1. Australian standard as 1926 1986. If a boundary fence is part of the pool fence the barrier must be 1 8m high.

This standard incorporates amendment no. Pool pumps pool pumps supplied in australia and new zealand should be tested to as nzs 60335 2 41 2004 household and similar electrical appliances safety particular requirements for pumps. Must be at least 1 2 metres high from the finished ground level. This standard is a modified edition of iec 60335 2 41 ed 3 1 and en 60335 2 41 2003.

1 australian standard. The following are the australian standards for pool fencing in nsw. Australian standard as 1926 1 2007. As 1926 1 2007 incorporating amendment no.

Or write to standards australia gpo box 476 sydney nsw 2001. Relevant to swimming pool australian standard 2012 trees vegetation and level objects can be found within 500mm of the boundary fence. Key pool fence measurements.