Attaching Metal Roofing

Drill and full assortment of drill bits.

Attaching metal roofing.

Our company definitely recommends screws over nails for attaching metal roofing to the purlins. 1 inch roofing nails. Steel panels rectangles or squares staple gun. Take care the first piece is aligned precisely perpendicular square to the edge.

Absolute steel recommends using metal self tapping screws with thin washers that have been properly compressed to ensure a secure seal. Diy metal roofing installations will require the following materials. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. Install metal panels or shingles align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.

This means that your vertical lines are all running square to your eave. Ladder or scaffolding tall enough to reach the roof jigsaw or power metal shears. Attaching roofing sheets to a purlin the 12 with a t 3 self drilling point has a drilling capability from 0 036 inch to 0 210 inch total steel thickness webb says. Install the roofing screws vertically along each rib in the panel.

Metal roofing installation proper metal roofing installation begins with the use of the right equipment starting with the screws used to anchor your panels or shingles to the structure. Measure the length of the roof and the breadth of one side. Before you start to install corrugated metal roofing you need to figure out how much you need. Add the metal panels.

Multiply those numbers and then double the result for the square footage of your roof. The t 1 has a mini drill point that can attach total steel thickness of 0 024 inch to 0 095 inch. Screws are much stronger than nails in terms of pull out strength they don t back out as readily as nails and it s possible to get a better seal with screws than nails. A good metal roof starts with the right materials.

It s important to start square because if the first panel is tilted a little bit all the panels that come after are going to be tilted as well. Take your first sheet of metal and place it on the roof so that it overhangs the edge at least 3 4 in 1 9 cm. When you re installing a metal roofing panel the first thing that you want to do is make sure you re starting square. Corrugated metal roofing generally comes in sheets that are 3x6 feet in size 18 square feet.