Attaching Fence Panels To A Brick Wall

Have a friend or family member help you hold the gate while you place a bubble level on the front of it.

Attaching fence panels to a brick wall.

Tear down alternate sections and replace with trendy metal slats. Position the gate so it stands plumb then swing the gate to the open position. I want to attach a 3in x 3in fence post to the end of a brick wall. I d just use a normal wall fixing plug and contersink the hole about 25 30mm into the post so that a 100mm scew would do.

Hold the board in place within the marks on the wall and push the masonry bit through the holes in the lattice into the brick. But by all means use the thunderbolts i just wondered why. Place a lead anchor in the hole in the brick. I like the rawlplug uno ones i find them superb in most applications.

Nail the opposite ends of the rails at the fence post with 8 penny galvanized nails. Drill holes approximately 1 1 4 inch deep into the brick. When you already have an imposing wall try to tone down the colours choose modish yet neutral hues. Attaching lattice panels to brick isn t a hard job at all.

This is how to put up a fence above a wall. I am building the fence from scratch i am using c24 sawn treated graded regularised timber 5x2 47x125mm 6. First you have to use a masonry bit to drill the hole in the brick. They come loose when used on fence posts in my experience anyway.

Attaching fence post to brick wall google groups. Set the gate aside. Before actually drilling into the wall or brick you will want to use a measuring tape as well as the panels to map out where everything will go. Pre drill the holes in the wood also.

Place the gate against the brick wall in the closed position. The problem is that the wall is only 9in 22cm from the house wall. Step 1 map it out. There are a few tools that you will need along with some steps that can help to guide you through the process.

Mark the mounting holes on the hinges onto the wall using a felt tip marker. Brick and metal interchange. I asked a related question without mentioning the short space here and resin fixing was suggested.