Attach Fascia Board Roof Trusses

Position the board against the trusses and nail it in place.

Attach fascia board roof trusses.

Rafters are cut in two pieces that are joined at an angle that creates the peak of the roof. Starting at a roof corner lift the first board into place and hold its top edge tightly against the bottom edge of the roof deck. Cut the board with a miter saw. Instructions for how to attach fascia board to roof trusses.

Bob vila helps carpenter bob ryley demonstrate the process of installing fascia board. This quick and simple instructional video from best rate repair s president jeff mudd will show you how to nail a fascia board to a rafter. Use 1 inch lumber in the appropriate width for your joists to create fascia. Measure up the rafter 45 3 4 inch from the cut end of the truss tail and snap a line along the trusses.

Use carpentry nails that are at least 2 3 inches 5 1 7 6 cm long so the board stays firmly in place. Instructions for how to attach fascia board to roof trusses use the carpenter s square and pencil to put a straight line at the mark. Roof trusses are made up of rafters and ceiling joists. However if you have gabled roof which means it has gabled ends you may have to create markings on the board to ensure that it fits the rafters.

Position the board against the trusses and nail it in place. Remove old fascia boards including old nails that are sticking out. Make the top edge of the fascia even with the top corner of the plumb cut and nail it into the butt end of every lookout block with galvanized finishing nails. Mark the place closest to the end of the board that aligns with the center of a joist.

If the rafter tails have uneven heights the fascia boards will be installed with a side bend also known as a crook or a crown. Nail the fascia boards twice with your soffits and roof joists. Put at least 2 nails at both ends of the fascia board into the joists. For more how to s visit.

For instance if you have hip roofs you can instantly tack the fascia board into the rafter. Next install the fascia boards onto the eave. Cut the board with a miter saw. As you can tell.

Instructions for how to attach fascia board to roof trusses use the carpenter s square and pencil to put a straight line at the mark. Put at least 2 nails at both ends of the fascia board into the joists. Repeat the process on the other end of the fascia board so it s held firmly in place.