For diyers just get a good quality styrofoam board and paste it on the wall.
Attach basement wall to concrete.
How to frame a basement wall the traditional framing way step 1.
Drill at least 1 4 inch deeper into the concrete than the fastener s embedment and suck dust out of the hole with a shop vac.
When you apply the glue do so vertically.
Did you get it.
Use firm pressure but don t push too hard.
Baseboard is easily attached to wood or plaster walls using nails but if you are gluing baseboard molding to a concrete floor you need to use a sturdy adhesive.
Drill a hole through the center of the 2x4 every 16 to 20 inches.
Drill the pilot hole.
No matter the reason attaching a 2 4 bottom plate to the concrete requires special tools and fasteners.
Use one of the suggested above and insulate the concrete wall.
Attaching the bottom plate of a wall to a concrete floor can be done using any of the following methods.
Let the drill do the work.
A powder actuated nailer is out of the question since nail depth would be impossible to regulate.
The issue as bud cline of the floor pro says is more about how to attach the cement board to the concrete.
Insulate the concrete wall.
Many times you wish you had more space to store things in the basement garage or even on the outside of the wall.
Attaching a shelf to a concrete wall is one of the best options.
Concrete screws cline says have heads that are too small to hold down the cement board.
Baseboard molding gives your home a finished professional look and it is a good choice when you are looking to add some elegance to your basement.
Masonry screws 5 the home depot are an easy solution for fastening a wall to concrete.
Attaching a shelf to a concrete wall is a great way to create space to store things in your home.
Hold the board in place by standing on it if possible.
Cut nails aka masonry nails concrete nails.
If using 2 3 4 screws put a piece of tap on the bit 3 from the tip.
When you buy the screws you ll also need to get a special bit that makes a pilot hole matched to the fastener.
A clean surface increases the bonding strength between the panels and wall.