Asphalt Roofing Starter Roll

The ends of the roll roofing should be flush with the underlying cant strips at the roof gable ends or rakes and the lower edge of the first course should be flush with the lower edge of the cant strip that was nailed along the lower roof edge.

Asphalt roofing starter roll.

The high quality properly positioned adhesive tightly locks the overlying shingles in place at the eaves and rakes helping to prevent blow off. You should then place the strip along the edge of the roof. A starter strip is an asphalt based shingle utilized to waterproof the eave and rake edges of your home during a re roof. Starter strips are typically roll roofing or shingles.

When you have finished this leave it to dry. Step 2 install your starter strip. Press down hard with the brush in order to fix the roll to the roof. The shingle starter strips are often installed with their tabs facing up the roof slope rotated 180 from their normal orientation.

As it won t be visible on the finished roof you don t need to worry about the look of your starter strip and whether it matches your architectural shingles. Quickstart peel stick starter roll is designed for fast and easy installation eliminating cutting and nailing of starter strips on the roof. You need to place starter strips of roll roofing along all edges of the roof so start by cutting pieces of roofing about 18 inches wide. The pro cut 6xr starter shingle roll is an easy cost saving alternative to the traditional method of cutting tabs from 3 tab shingles to form a starter course.

High quality properly aligned adhesive tightly locks the shingles in place and helps prevent shingle blow off. Quickstart peel stick starter roll is designed for fast and easy installation. The pro cut 6xr starter shingle roll may also be used as a rake edge strip to prevent wind uplift of the field shingles. The upper edge of the starter course is nailed in place.

Starter strips are placed along the lower edge of the roof below the bottom row of shingles to achieve double coverage for the bottom row. Quickstart peel stick starter roll is designed for fast and easy installation eliminating cutting and nailing of starter strips on the roof. That s because some roofing contractors try to use a cut up 3 tab strip shingle as the starter course on your roof. Unfortunately cut up shingles may not have properly positioned adhesive to help reduce the risk of shingle blow off.

Take a small piece from the asphalt roll roofing and apply a layer of caulking to the eaves of the roof. The starter edge will help seal the edges and cover your shingle joints. You can instead use the same starter strip that you d use for 3 tab shingles. Take a look at your roof and you ll see how the field roofing shingles are overlapped to create seamless flow of water without penetration.